ABUS TV3220 - Manual (Page 132)

ABUS VMS ABUS Security-Center GmbH & Co. KG
System manual
Version 7.3 132
When calibration has been made, the various functions (e.g. zoom or focus) can be
connected to the joystick buttons. To define individual functions, always click first on the
desired button and then on the corresponding joystick switch to be used.
Repeat this process until all elements have been connected.
3.8.5 Miscellaneous
In this section, various settings can be made which relate to one partition of the entire system.
The line underscored in yellow shows the system partition for which the settings displayed
below apply.
For example, a partition defines the possible configuration when using touch-screen monitors.
The zoom function or access to the context menu (right mouse-click) can be switched off here.
To change a setting, click on the value to be changed in the “Value/Status” column and select
the new value from the displayed selection box.
Save your settings, then click on Apply so that the software is restarted with the new settings.
3.8.6 Activating and deactivating voice output
Version 6.0 and higher of ABUS VMS features voice output. When playing voice output, there
is a distinction between user and system sounds.
The user sounds are played, for example, when the software is started or the system
administration is opened or closed.
The system sounds indicate malfunctions such as camera or hard drive failures.
To completely switch off the voice output, deactivate User voice output and System voice
output under Various (Miscellaneous menu view) in the system configuration.
3.9 Importing / exporting the system configuration
The ABUS VMS software is equipped with an import / export function, which can be used to
restore the system quickly in the event of errors. The current settings can then be saved or
restored quickly in this way.
To export the settings, open the system
configuration and select the Im-/Export
button on
the top edge of the screen.
The Import... and Export... buttons are used to
load or save the current configuration.
The Load and edit... button is used to load an
existing setting to the view and change it as
required. The current active configuration is not
overwritten during the load process.
When a configuration file is loaded and changed,
then it must be saved in the import/export dialog (Save and Close ).