ABUS TV3220 - Manual (Page 119)

ABUS VMS ABUS Security-Center GmbH & Co. KG
System manual
Version 7.3 119
3.7 Network configuration
All settings used for incoming and outgoing communication are managed in the network
configuration. This includes the configuration of networks / ISDN cards or notifications to
specific recipients. All possible settings are dealt with individually below.
3.7.1 Configuration of the network module (TCP/IP)
The network module is used to transfer images to another ABUS system using the local
network or the Internet.
Security or bandwidth settings can be made for this module in the system configuration.
To change the settings, open the system configuration and switch the view switch to the
Network view. Select TCP/IP from the list on the left.
The network module can be
switched
on and off here.
Additionally, incoming calls can
be activated or restricted to the
clients in the host list.
If a remote system is connected
(e.g.
over DSL), then the
bandwidth for image transfer can
be adjusted under Expected
Bitrate.
From version 6.6 onward, you
have the option of individually
configuring the network port to be
used.
From version 7.0 onward, you can individually select the web interface port.
Note:
A connection to another system over the network is only possible when the network module is
switched on. This also applies to access attempts from the web application.