Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 101)

Setup Menu 100
Access from the Computer Program:
From the
Status screen , press the "SETUP" button. The "Analog Clutch Input" option is found in the "Analog1
Config" dialog box under the "Analog1" Tab. Click "Analog Clutch Input" to enable the Analog Clutch Input
feature or "OFF" to disable the feature.
Analog1 Clutch Activation Percentage
This setting allows the user to define at what clutch percentage the clutch arming occurs.
The valid range is 10.0-100.0 percent in 0.1 percent increments.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Analog1
Setup Menu selection is highlighted, and then press the “ENTER” button twice. Press the down arrow until the
"Activation%" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow
buttons adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit
with no change.
Access from the Computer Program:
From the
Status screen , press the "Setup" button. The "Activation Percent" setting is found in the "Analog
Clutch Setup" dialog box under the "Analog1" Tab. Click the "UP" and "DOWN" arrow buttons or type in any
numeric value in the valid ranges shown above.
Analog1 Clutch Activation Hysteresis
This setting allows the user to set a hysteresis percentage for the clutch activation percentage. Refer to