Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 130)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 129
7.13 Nitrous PSI Menu
The following options are found in the Nitrous PSI Menu, which can be accessed by the "SETUP" button on the
main screen or by clicking the Nitrous Sensor tab in the Setup menu of the computer software. This menu
allows the user to data log the nitrous pressure. Having this sensor in the system allows you to perform closed
loop bottle heater control using one of the NCC-002 relay outputs.
Default Sensor Setup
Use this setting to configure the controller to use the default nitrous pressure sensor. If you are not using the
default LPE 0-2000 PSI nitrous pressure sensor (PN: 480272000), the chosen sensor for the application MUST
be a 0-5 volt linear output sensor.
Access from the Controller:
From the Main screen press the “SETUP” button, press the “DOWN” arrow button repeatedly until the Nitrous
PSI Menu is highlighted and then press the “ENTER” button. Press the "ENTER" button to select the "Default
Sensor Setup" option, then the “YES” or “NO” button to change the current selection. If the “NO” button is
pressed no change will be made.
Access from the Computer Program:
From the
Status screen , press the "SETUP" button. The "Default Nitrous Sensor" setting is found under the
"Nitrous Sensor" Tab. Click "Accept" to select the default fuel sensor setting.
Nitrous Pressure Minimum Voltage
This setting should be set to the voltage the Nitrous Sensor outputs at the minimum nitrous pressure.
The Valid Range is 0.0 to 5.0 volts in .1 volt increments.
Access from the Controller:
From the Main screen, press the “SETUP” button, press the “DOWN” arrow button repeatedly until the Fuel Psi
Menu selection is highlighted, and then press the “ENTER” button. Press the down arrow until the "N2O Psi Min