Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 126)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 125
Fuel Pressure Minimum Value
This setting should be the fuel pressure that corresponds to the fuel sensor minimum voltage.
The Valid Range is 0 to 250 PSI in 1 PSI increments.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Fuel PSI
Menu selection is highlighted, and then press the “ENTER” button. Press the down arrow until the "Fuel PSI Min
Value" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow buttons
adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit with no
change.
Access from the Computer Program:
From the
Status screen , press the "Setup" button. The "Sensor Min PSI" option is found in the "Fuel Sensor
Setup" dialog box under the "Fuel Sensor" Tab. Click the "UP" and "DOWN" arrow buttons or type in any
numeric value in the valid ranges shown above.
Fuel Pressure Maximum Value
This setting should be the fuel pressure that corresponds to the fuel sensor maximum voltage.
The Valid Range is 0 to 250 PSI in 1 PSI increments.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Fuel PSI