Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 96)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 95
This setting controls the RPM to activate the +12 volt Shift Light output on the NCC-002.
The Valid Range is 1000 to 16000 RPM in 100 RPM increments.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Shift
Setup menu selection is highlighted and then press the “ENTER” button twice. Using the “LEFT” and ”RIGHT”
arrow buttons adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to
exit with no change.
Access from the Computer Program:
From the
Status screen , press the "Shift RPM" button. The "Shift RPM Default" option is found in the "Shift
RPM(s)" dialog box under the "Options" Tab. Click the "UP" and "DOWN" arrow buttons or type in any numeric
value in the valid ranges shown above.
7.5 Throttle Position Sensor (TPS) Setup Menu
The following options are found in the TPS setup menu, which can be accessed by the "SETUP" button on the
main screen of the controller or the TPS Input tab on the Setup screen of the computer software. The TPS
accepts rising or falling voltage signals. Note that the Throttle Position Sensor (TPS) and the Accelerator Pedal
Position sensor (APP) are NOT the same. While both the TPS and APP sensors function by relaying a voltage
to the ECM that translates into the degree of engagement, the measurements and their consequential voltages
are not the same. While the NCC-002 can accept either signal, LPE recommends that the NCC-002 be
connected to the TPS in most cases.
See Appendix D: Glossary of Terms for more information on the Throttle Position Sensor.
TPS Activation Option
The TPS Activation Option allows the throttle position sensor input to control system activation. The Arming
Input must be used even if this option is selected.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the TPS
Setup Menu selection is highlighted and then press the “ENTER” button. Press the "ENTER" button to select the
TPS Arming Option, then the “YES” or “NO” button to change the current selection. If the “NO” button is pressed
no change will be made.