Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 75)

Nitrous Menus: Nitrous1 (N2O-1) and Nitrous2 (N2O-2) 74
Nitrous Graph is displayed under the "Nitrous Graph" Tab. To move a single point, click on it and drag with
mouse up or down. You can use the "UP" and "Down" arrow keys to move the data point as well. By pressing
CTRL + UP/DOWN keys, you can move the data point in fine precision. To set an Edit point, double click on a
data point. An "X" will appear to mark the Edit point. When you select another point with a single click all points
between the Edit point and the Highlight point will auto fill as you drag the point. The SHIFT+LEFT/RIGHT keys
move the Highlight between data points. Use the scroll wheel and the right button on the mouse to zoom in or
out. Single click off from a data point and drag the mouse to move around a zoomed in window. Hit "ESC" to
deselect the edit point. You can also single click directly on highlighted Edit point to cancel. Click CTRL-Z to
undo.
Right-clicking on the graph will display a menu from which the graph can be manipulated as well, as shown
below.
IMPORTANT—When Saving a new Nitrous setup, the software will compare the Nitrous percentage settings to
the current Fuel percentage settings. If the Fuel percentage for a given pulse is less than the
Nitrous percentage
minus the Fuel Trim percentage (See Setup Menu), then the Fuel percentage will automatically be adjusted to
Nitrous percentage minus the Fuel Trim percentage. If the Fuel Trim percentage is 0, this will result in the Fuel
percentage being greater than or equal to the Nitrous percentage. To allow full control of the Fuel percentage
versus Nitrous percentage set the Fuel Trim Option to 100%. Do this with caution as a lean condition can and
will result if improper settings are entered!
See Appendix B: Nitrous & Fuel Operation for more information.
6.4 Fuel Graph Setup
Fuel Setup
The Fuel Percentage can be adjusted for each Pulse during the Progressive Ramp. This is done using a 2-D
Graph Editor. Please see Basic Editing Instructions below. The Fuel Percentage/Ramp can be adjusted
independently of the Nitrous (see Nitrous Graph Setup).