Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 110)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 109
Setup Menu selection is highlighted, and then press the “ENTER” button. Press the down arrow until the "AFR
Max Value" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow
buttons adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit
with no change.
Access from the Computer Program:
From the
Status screen , press the "Setup" button. The "AFR Maximum Value" setting is found in the "AFR Input
Setup" dialog box under the "Air Fuel Ratio" Tab. Click the "UP" and "DOWN" arrow buttons or type in any
numeric value in the valid ranges shown above.
7.9 Relay1 and Relay2 Setup Menus
The Relay1 output is a NCC-002 controlled ground output. The Relay2 output is a NCC-002 controlled +12 volt
output.
The following options are found in both the Relay1 and Relay2 setup menus, which can be accessed by the
"SETUP" button on the main screen or through the Relay1 and Relay2 buttons in the computer software. The
control options found in these menus are used to determine the parameters for enabling either Relay1 or
Relay2. Any combination of enabling control options can be used to enable Relay1 and Relay2.
Arming Input Control Option
If this option is enabled, the selected Relay output is controlled by the state of the Arming Input and any other
control options that are enabled.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the desired
Relay Menu is highlighted and then press the “ENTER” button. Press the "ENTER" button to select the "Act
Input Ctrl" option, then the “YES” or “NO” button to change the current selection. If the “NO” button is pressed no
change will be made.