Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 144)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 143
8.2 Managing Data Logs on the Controller and Computer
The following options allow the user to manage and view the data logs that are saved on the computer, as well
as the data log saved into memory on the NCC-002 controller.
Warning: A new data log can not be created until the existing log is erased. The memory in the NCC-002
controller can only hold one (1) data log at a time, so it is very important to back up prior data logs through the
computer software.
Load Data Log from Controller
This option allows the user to upload a data log from the controller to the computer program where it can be
viewed and saved.
Access from the Computer Program:
There are two (2) ways to load a data log from the controller, denoted below by the bullet points.
•
From the Status screen , press the "DATA" button. The "Read Data from Controller" option is found in the
"NCC Data Log Commands" dialog box under the "Options" tab.
•
From the Status screen , click on the "Load Data Log from Controller" button in the toolbar on the upper left-
hand side of the window, as shown below.
Once either of the "Read Data from Controller" buttons are pressed, a dialog box will appear prompting the user
to save any unsaved current data log file to the computer as it would be replaced by the uploaded data log from
the controller.
After the current data log is saved or clicking "NO", the status window will pop up to show the progress of the
upload.