Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 133)

Setup Menu 132
Max" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow buttons
adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit with no
change.
Access from the Computer Program:
From the
Status screen , press the "Setup" button. The "Sensor Max PSI" option is found in the "Nitrous Sensor
Setup" dialog box under the "Nitrous Sensor" Tab. Click the "UP" and "DOWN" arrow buttons or type in any
numeric value in the valid ranges shown above.
7.14 Data Log Menu
The following options are found in the Data Log Menu, which can be accessed by the "SETUP" button on the
main screen or by clicking the Options tab in the Data menu of the computer software. The settings in this
menu allow the controller to log data only after the criteria in the following sub-sections are satisfied. The data
log enable parameters are any parameters that, along with the arming input, allow the controller to log data. If
no data log enable parameters are selected, the controller will start the data log when the arming switch is
activated. Once the data log is activated, the logging of data will continue even if the data log enable parameters
fall below their present settings.
Clutch Enable Option
Enabling the Clutch Enable Option allows the NCC-002 to log data when the clutch is released after the arming
switch and clutch pedal are engaged. In other words, data logging is disabled while the clutch pedal is
depressed. When the clutch pedal is released, the data logging feature is enabled. In order to prevent the data
log from beginning prematurely, the arming switch should be enabled after the clutch is engaged. Note: This
option applies to the Clutch Input signal and not the CPP Sensor on Analog1.
Example - You have already staged and are at the starting line ready to launch. Depress the clutch, engage the
arming switch, and the data log feature will engage when the clutch is released.
Access from the Controller:
From the Main screen press the “SETUP” button, press the “DOWN” arrow button repeatedly until the Data Log
Menu is highlighted and then press the “ENTER” button. Press the "ENTER" button to select the "Clutch Enable"
option, then the “YES” or “NO” button to change the current selection. If the “NO” button is pressed no change
will be made.