Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 User Manual
Page 172
Advertising
Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions
171
output from the ECM. There should now be a blue dot on the depressed ‘Pulse’ button, showing that the
selection has been changed.
4. Save the calibration and then flash the new calibration to the vehicle.
5. Refer to the
Hall Input Menu
section of these instructions for information on how to calibrate the NCC-002 to
correctly read the VSS signal.
6. Since no other device will be connected to the VSS signal output and the ECM, make sure to enable the pull-
up resistor on the NCC-002.
NOTE: Similar changes will be required if using HP Tuners or any other programming system
Advertising