Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 142)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 141
the controller, the new program will replace one of the three user programs already on the controller, which
means that the program that was replaced is erased out of the controller's memory. The only way to retrieve
and reuse the program is if the program was backed up on the computer.
Access from the Computer Program:
There are three (3) ways to load a user program from the controller, denoted below by the bullet points.
•
Press Ctrl+Alt+O
•
From the Status screen , click on the File button in the upper left-hand corner of the window, then click on the
"Load User Program from Controller" button.
•
From the Status screen , click on the "Load User Program from Controller" button in the toolbar on the upper
left-hand side of the window, as shown below.
Once the "Load User Program from Controller" button has been pressed, a status window will appear showing
the status of the upload, as shown in the illustration below. Once the status window disappears, the upload of
the user program is complete it becomes your current user program on the computer software. NOTE: Since
the uploaded user program becomes the current program, you will be prompted to save any changes to the
current program.