Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 149)

User Program Files, Data Logs, and Other Software Options 148
data to the associated NCC-002 settings.
Access from the Computer Program:
From the Status screen , press the "Data" button. The "Load NCC User Program from Data Log" button is found
in the "Data Log File" dialog box under the "Options" Tab.
After Pressing the "Load NCC User Program from Data Log" button, a dialog box will open to confirm that a user
program was extracted from the data log.
8.3 Viewing Data Logs
The following sub-sections explain how to view data logs in the "Nitrous Control Center" computer program.
The data log chart feature allows the user to view readings of the following variables.
•
Hall Input Frequency
•
TPS Percentage
•
Vehicle MPH
•
Shift Input
•
Engine RPM
•
TPS Voltage
•
Fuel PSI
•
Timer Output Status
•
Nitrous1 Percentage
•
Clutch Percentage
•
Nitrous PSI
•
Shift Light Status
•
Fuel1 Percentage
•
Air-Fuel Ratio
•
Gear Position
•
Relay1 Output Status
•
Nitrous2 Percentage
•
AFR Input Voltage
•
Battery Voltage
•
Relay2 Output Status
•
Fuel2 Percentage
•
Analog1 Input
•
Arming Input
•
Stage1 Activation Status
•
Analog Out
•
Analog2 Input
•
Clutch Input
•
Stage2 Activation Status
The Data Log Chart
The NCC-002 has the ability to log several types of data during each pass. Once the data has been loaded
from the controller, the data can be viewed in the "Data View" tab by clicking the "Data" button, as shown below.