Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 122)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 121
Pulse Per Mile Setting (Live Data)
This option is only available on the controller and allows the user to set the correct Pulse Per Mile setting for the
vehicle using live data from the vehicle.
The valid range is 1000-20000 in 1 Pulse Per Mile (PPM) increments.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Hall
Input Menu selection is highlighted, and then press the “ENTER” button twice. Press the "DOWN" arrow button
until the either the "Pulse Per Mile" selection is highlighted and then press the "ENTER" button. Once the
vehicle is going 60 miles per hour, press the "SET" button to accept the new Pulse per mile calibration or press
the "BACK" button to exit with no change.
Manual Pulse Per Mile Setting
This setting allows the user to manually set the number of pulses per mile.
The valid range is 1000-20000 in 1 Pulse Per Mile (PPM) increments.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Hall
Input Menu selection is highlighted, and then press the “ENTER” button twice. Press the "DOWN" arrow button
until the either the "Manual Pulse Per Mile" selection is highlighted and then press the "ENTER" button. Use the
“LEFT” and ”RIGHT” arrow buttons adjust the setting. Press the “SAVE” button to accept the new setting or
press the “ESC” button to exit with no change.
Access from the Computer Program:
From the
Status screen , press the "SETUP" button. The "Pulse Per Mile" setting is found in the "MPH Setup"
dialog box under the "Hall Input" Tab. Click the "UP" and "DOWN" arrow buttons or type in any numeric value in