Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 143)

User Program Files, Data Logs, and Other Software Options 142
Save User Program to Controller
This option allows the user to flash the current user program file, as well as any other saved user program to the
controller.
Warning: The memory on the controller is only capable of holding one program at a time. This program
contains 3 different sets of user defined settings. All other user programs must be backed up by using the
Nitrous Control Center software. When the you flash a new user program to the controller, the new program will
erase the original program and load the new program onto the controller. The only way to retrieve and reuse the
program is if the program was backed up on the computer.
Access from the Computer Program:
There are three (3) ways to save a User Program File to the controller, denoted below by the bullet points.
•
Press Ctrl+Alt+S
•
From the Status screen , click on the File button in the upper left-hand corner of the window, then click on the
"Save User Program to Controller" button.
•
From the Status screen , click on the "Save User Program to Controller" button in the toolbar on the upper left-
hand side of the window, as shown below.
Once the "Save User Program to Controller" button has been pressed, a status window will appear showing the
status of the upload, as shown in the illustration below. Once the status window disappears, the flashing of the
user program is complete and the flashed user program replaces the current program on the controller.