Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 User Manual
Page 106
Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions
105
Setup Menu selection is highlighted, and then press the “ENTER” button. Press the down arrow until the "AFR
NOX Disable" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow
buttons adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit
with no change.
Access from the Computer Program:
From the
Status screen
, press the "Setup" button. The "AFR Nitrous Disable" setting is found in the "AFR
Disable Setup" dialog box under the "Air Fuel Ratio" Tab. Click the "UP" and "DOWN" arrow buttons or type in
any numeric value in the valid ranges shown above.
AFR Nitrous Disable Delay
This setting controls the amount of time the Air Fuel Ratio must be above the AFR Disable setting before
disabling the nitrous system. This allows the system to filter out short Lean spikes.
The Valid Range is 0.000 to 1.000 Seconds in .01 second increments.
Access from the Controller:
From the
Main screen
, press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the AFR
Setup Menu selection is highlighted, and then press the “ENTER” button. Press the down arrow until the "AFR
Disable Delay" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow
buttons adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit
with no change.
Access from the Computer Program:
From the
Status screen
, press the "Setup" button. The "AFR Disable Delay" setting is found in the "AFR Disable
Setup" dialog box under the "Air Fuel Ratio" Tab. Click the "UP" and "DOWN" arrow buttons or type in any
numeric value in the valid ranges shown above.