Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 102)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 101
Appendix D: Glossary of Terms for an explanation of how a hysteresis works.
The valid range is 0.0% to 5.0% in 0.1% increments (of full scale, 100%).
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Analog1
Setup Menu selection is highlighted, and then press the “ENTER” button twice. Press the down arrow until the
"Hysteresis%" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow
buttons adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit
with no change.
Access from the Computer Program:
From the
Status screen , press the "Setup" button. The "Activation Hystersis" setting is found in the "Analog
Clutch Setup" dialog box under the "Analog1" Tab. Click the "UP" and "DOWN" arrow buttons or type in any
numeric value in the valid ranges shown above.
Calibrate Clutch Pedal Position Sensor Signal
This option is only available on the controller and allows the user to set the released and depressed clutch
voltages using live data from the vehicle.
The valid range is 0.00-5.00 in 0.01 Volt increments.
Access from the Controller:
From the
Main screen , press the "SETUP" button. Press the "DOWN" button repeatedly until the Analog1 Setup
Menu selection is highlighted, and then press the "ENTER" button twice. Press the down arrow until the "Set
Clutch Voltage" selection is highlighted and then press the "ENTER" button. With the vehicle powered up and
the clutch pedal released, press the "SET MIN" button. Next, fully depress the clutch pedal and press the "SET
MAX" button. The clutch voltages that were observed by the controller will be displayed and this should be used
to verify correct operation.