Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 104)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 103
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Analog1
Setup Menu selection is highlighted, and then press the “ENTER” button twice. Press the down arrow until the
"Set Depressed Voltage" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and
”RIGHT” arrow buttons adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC”
button to exit with no change.
Access from the Computer Program:
From the
Status screen , press the "SETUP" button. The "Clutch Pedal Depressed Voltage" setting is found in
the "Analog Clutch Setup" dialog box under the "Analog1" Tab. Click the "UP" and "DOWN" arrow buttons or
type in any numeric value in the valid ranges shown above.
7.7 Analog2 Setup Menu
There is currently one setting, Data Log Erase Option, available in the Analog2 Setup Menu.
Activating the Data Log Erase Option allows the Data Log memory to be Erased/Activated by applying a +5V
to +12V signal to the Analog2 Input. This option allows you to put a user controlled switch in the vehicle to
manually erase the data log.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Analog2
Setup Menu selection is highlighted and then press the “ENTER” button. Once in the Analog2 Setup menu,
press the "ENTER" button to select the Erase option. Press the “YES” or “NO” button to change the current
selection. If the “NO” button is pressed no change will be made.
Access from the Computer Program:
From the
Status screen , press the "SETUP" button. The "Data Log Erase Enable" option is found in the