Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 134)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 133
Access from the Computer Program:
From the
Status screen , press the "Data" button. The "Clutch Input" option is found in the "Data Log Enable
Parameters" dialog box under the "Options" Tab.
TPS Enable Option
Enabling the TPS Enable Option disables the data log feature of the NCC-002 until the arming input is engaged
and the desired TPS setting is achieved.
Access from the Controller:
From the Main screen press the “SETUP” button, press the “DOWN” arrow button repeatedly until the Data Log
Menu is highlighted and then press the “ENTER” button. Press the "DOWN" arrow button until the "TPS Enable"
option is highlighted, then press "ENTER". Press the “YES” or “NO” button to change the current selection. If
the “NO” button is pressed no change will be made.
Once the TPS Enable option is enabled, you will be sent back to the Data Log Menu where you can either press
the "BACK" button to exit or the "ENTER" button to adjust the TPS Enable Percent and Hysteresis Percent
settings. Refer to
Appendix D: Glossary of Terms for an explanation of how a hysteresis works.