Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 User Manual
Page 141
User Program Files, Data Logs, and Other Software Options
140
New User Program File
This option allows the user to create a new user program file that can be calibrated on the computer and flashed
to the controller.
Access from the Computer Program:
There are three (3) ways to create a new User Program File, denoted below by the bullet points.
•
Press Ctrl+N
•
From the
Status screen
, click on the File button in the upper left-hand corner of the window, then click on the
"Save User Program File" button.
•
From the
Status screen
, click on the "Save User Program File" button in the toolbar on the upper left-hand
side of the window, as shown below.
NOTE: If you have made changes to the current program and have not saved them, you will be prompted to
save the current program.
Load User Program from Controller
This option allows the user to upload a user program file from the controller so that it can be further modified or
backed up. This feature is very important as the memory on the controller is only capable of holding three (3)
programs at a time. All other user programs must be backed up by using the Nitrous Control Center software.
If the controller already has three existing user programs and the user attempts to flash a fourth user program to