Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 60)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 59
5 Global Menu / Setup-Options
The Global Menu of the NCC-002 Nitrous Control Center is where all of the global settings are located. The
global settings are the settings that apply to all three user-defined programs. The Global menu can be
accessed from the Main Screen by pressing the far left navigation button on the controller. The following sub-
sections detail the location and function of each setting in the Global Menu.
5.1 Current Program
There are 3 user-defined data setups available. All user settings will be saved when selecting a new data setup
from the list. This way multiple user setups can be stored and recalled at a later time. Example - you have a
setup that is working well, but you would like to try a few different settings. You could then select and copy all
current setup data to a new setup and make changes without losing the original setup.
Access from the Controller:
From the
Main screen , press the “GLOBAL” button. Press the “ENTER” button to select the Current Program
menu. Using the “UP” and “DOWN” arrow buttons select the desired setup and press “ENTER”. You will then be
prompted to copy the current program to the new setup selected. If you choose “YES” the current setup will be
copied to the new setup selected.
NOTE—When asked to make a selection from a “Message Box” the default selection will be chosen after 20
seconds.
Access from the Computer Program:
From the
Status screen , press the "SETUP" button. The current program is found in the "Program" dialog box
under the "Options" Tab. Click on the desired program from the pull down menu.
5.2 Copy Current Program
The current program may be copied to another program after selecting to which program the current user data
is to be copied. If the current program is selected, the request will be ignored.