Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 128)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 127
Fuel PSI Nitrous Oxide Disable
This setting determines the fuel pressure at which the nitrous system is disabled. A setting of 0.0 will disable
this feature. This setting is used along with the Fuel PSI Delay and Fuel PSI Disable Percent settings.
The Valid Range is 0.0 to 150.0 PSI in .1 PSI increments.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Fuel PSI
Menu selection is highlighted, and then press the “ENTER” button. Press the down arrow until the "Fuel PSI
Disable" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow
buttons adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit
with no change.
Access from the Computer Program:
From the
Status screen , press the "Setup" button. The "Fuel PSI Nitrous Disable" setting is found in the "Fuel
PSI Disable Setup" dialog box under the "Fuel Sensor" Tab. Click the "UP" and "DOWN" arrow buttons or type
in any numeric value in the valid ranges shown above.
Fuel PSI Nitrous Disable Delay
This setting controls the amount of time the Fuel Pressure must be below the Fuel PSI disable setting before
disabling the nitrous system.
The Valid Range is 0.000 to 1.000 Seconds in .01 Second increments.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Fuel PSI
Menu selection is highlighted, and then press the “ENTER” button. Press the down arrow until the "Fuel Disable
Delay" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow buttons
adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit with no
change.