Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 93)

Setup Menu 92
Access from the Computer Program:
From the
Status screen , press the "Timer" button. The "Timer Delay" option is found in the "Time Based Setup"
dialog box under the "Options" Tab. Click the "UP" and "DOWN" arrow buttons or type in any numeric value in
the valid ranges shown above.
Timer Duration
This setting controls the amount of time the Timer Out remains "ON" after the delay has expired. A setting of 0
will disable this option and the output will remain "ON" while the system is activated.
The valid range is 0.000-9.990 in .01 second increments.
Access from the Controller:
From the Main screen press the “SETUP” button and then press the “ENTER” button. Press the "DOWN"
button continuously until the "Timer Setup Menu" is selected, then press "ENTER". Press the "DOWN" button
continuously until the "Timer Duration" setting is highlighted, then press "ENTER". Using the “LEFT” and
”RIGHT” arrow buttons, adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC”
button to exit with no change.
Access from the Computer Program:
From the
Status screen , press the "Timer" button. The "Timer Duration" option is found in the "Time Based
Setup" dialog box under the "Options" Tab. Click the "UP" and "DOWN" arrow buttons or type in any numeric
value in the valid ranges shown above.
Timer RPM Output On
This setting controls the RPM at which the timer is activated if the timer is setup as a RPM window switch
controlled output. The RPM On setting must be at least 500 RPM's lower than the RPM Off setting.
The valid range is 1000-15500 in 100 RPM increments.
Access from the Controller:
From the Main screen press the “SETUP” button and then press the “ENTER” button. Press the "DOWN"