Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 80)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 79
Valid Range is 0.000 to 0.250 seconds.
Access from the Controller:
From the
Main screen , select the stage by pressing either the "N2O-1" button or the "N2O-2" button. Press the
“DOWN” arrow button repeatedly until the "Fuel Advance" menu selection is highlighted and then press the
“ENTER” button. Using the “LEFT” and ”RIGHT” arrow buttons adjust the setting. Press the “SAVE” button to
accept the new setting or press the “ESC” button to exit with no change.
Access from the Computer Program:
From the
Status screen , select the stage by pressing either the "Nitrous1" button or the "Nitrous2" button. The
"Fuel Advance" setting is found in the "Fuel Advance Time" dialog box under the "Options" Tab. Click the "UP"
and "DOWN" arrow buttons or type in any numeric value in the valid ranges shown above.
See Appendix B: Nitrous & Fuel Operation for more information.
6.9 Nitrous Gear Position
This option allows the nitrous to be initiated by gear position. Example-if the nitrous shift count is set to 3rd gear
the nitrous would not start until the system is armed and the vehicle has reached 3rd gear. The Nitrous delay
timer will not start until the vehicle is in the selected gear position.
The valid range is integer numbers from 1 to 6.
Access from the Controller:
From the
Main screen , select the stage by pressing either the "N2O_1” button or the "N2O-2" button. Press the
“DOWN” arrow button repeatedly until the "Nitrous Gear Pos" setting is highlighted and then press the “ENTER”
button. Using the “LEFT” and ”RIGHT” arrow buttons adjust the setting. Press the “SAVE” button to accept the
new setting or press the “ESC” button to exit with no change.
Access from the Computer Program:
From the
Status screen , select the stage by pressing either the "Nitrous1" button or the "Nitrous2" button. The
"Gear Position" setting is found in the "Nitrous Start Gear Position" dialog box under the "Options" Tab. Click
the "UP" and "DOWN" arrow buttons or type in any numeric value in the valid ranges shown above.