Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 121)

Setup Menu 120
Access from the Computer Program:
From the
Status screen , press either the "Nitrous1" or "Nitrous2" buttons. The "Nitrous OFF MPH" setting is
found in the "Nitrous Control MPH" dialog box under the "Options" Tab. Click the "UP" and "DOWN" arrow
buttons or type in any numeric value in the valid ranges shown above.
Nitrous1 and Nitrous2 MPH Hysteresis Percentage Setting
This setting determines the hysteresis percentage for the activation of both nitrous stages at the minimum and
maximum MPH. Refer to
Appendix D: Glossary of Terms for an explanation of how a hysteresis works.
The valid range is 0.0%-5.0% in 0.1% increments (percentage of full scale, 255 MPH). 1% is 2.55 MPH.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Hall
Input Menu selection is highlighted, and then press the “ENTER” button twice. Press the "DOWN" arrow button
until the either the MPH1 or MPH2 hysteresis percentage selection is highlighted and then press the "ENTER"
button. Use the “LEFT” and ”RIGHT” arrow buttons adjust the setting. Press the “SAVE” button to accept the
new setting or press the “ESC” button to exit with no change.
Access from the Computer Program:
From the
Status screen , press either the "Nitrous1" or "Nitrous2" buttons. The "Hysteresis" setting is found in
the "Nitrous Control MPH" dialog box under the "Options" Tab. Click the "UP" and "DOWN" arrow buttons or
type in any numeric value in the valid ranges shown above.