Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 125)

Setup Menu 124
Access from the Computer Program:
From the
Status screen , press the "Setup" button. The "Sensor Min Voltage" option is found in the "Fuel Sensor
Setup" dialog box under the "Fuel Sensor" Tab. Click the "UP" and "DOWN" arrow buttons or type in any
numeric value in the valid ranges shown above.
Fuel Pressure Maximum Voltage
This setting should be set to the voltage the Fuel Sensor outputs at the maximum fuel pressure.
The Valid Range is 0.0 to 5.0 volts in .1 volt increments.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Fuel PSI
Menu selection is highlighted, and then press the “ENTER” button. Press the down arrow until the "Fuel PSI Max
Volt" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow buttons
adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit with no
change.
Access from the Computer Program:
From the
Status screen , press the "Setup" button. The "Sensor Max Voltage" option is found in the "Fuel
Sensor Setup" dialog box under the "Fuel Sensor" Tab. Click the "UP" and "DOWN" arrow buttons or type in
any numeric value in the valid ranges shown above.