Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 103)

Setup Menu 102
OR
Manually Set Clutch Pedal Released Voltage
This setting allows the user to manually set the input voltage seen by the controller when the clutch pedal is
released.
The valid range is 0.00-5.00 in 0.01 volt increments.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Analog1
Setup Menu selection is highlighted, and then press the “ENTER” button twice. Press the down arrow until the
"Set Released Voltage" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and
”RIGHT” arrow buttons adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC”
button to exit with no change.
Access from the Computer Program:
From the
Status screen , press the "SETUP" button. The "Clutch Pedal Released Voltage" setting is found in the
"Analog Clutch Setup" dialog box under the "Analog1" Tab. Click the "UP" and "DOWN" arrow buttons or type in
any numeric value in the valid ranges shown above.
Manually Set Clutch Pedal Depressed Voltage
This setting allows the user to manually set the input voltage seen by the controller when the clutch pedal is
depressed.
The valid range is 0.00-5.00 in 0.01 Volt increments.