Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 72)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 71
Final Percent setting. If the Start percent is greater than the Final percent the ramp will progress backwards.
The Valid Range is 0% to 100% in 1% increments.
Access from the Controller:
From the
Main screen , select the stage by pressing the “N2O-1” button or the "N2O-2" button. Press the
“DOWN” arrow button repeatedly until the "Nitrous Quick Setup" menu selection is highlighted and then press
the “ENTER” button. Using the “UP” and ”DOWN” arrow buttons, select the "Start Percent" setting and hit
"ENTER". Adjust the setting and press the “SAVE” button to accept the new setting or press the “ESC” button to
exit with no change.
Access from the Computer Program:
From the
Status screen , select the stage by pressing either the "Nitrous1" button or the "Nitrous2" button. The
"Nitrous Start Percent" setting is found in the "Nitrous Quick Setup" dialog box under the "Nitrous Graph" Tab.
Click the "UP" and "DOWN" arrow buttons or type in any numeric value in the valid ranges shown in the different
settings below. Press the "APPLY" button to confirm the changes.
Final Percent
This setting determines the Nitrous Final percentage. The Final Percent can be less than or greater than the
Start Percent setting. If the Start percent is greater than the Final percent the ramp will progress backwards.
The Valid Range is 0% to 100% in 1% increments.
Access from the Controller:
From the
Main screen , select the stage by pressing the “N2O-1” button or the "N2O-2" button. Press the
“DOWN” arrow button repeatedly until the "Nitrous Quick Setup" menu selection is highlighted and then press
the “ENTER” button. Using the “UP” and ”DOWN” arrow buttons, select the "Final Percent" setting and hit
"ENTER". Adjust the setting and press the “SAVE” button to accept the new setting or press the “ESC” button to
exit with no change.