Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 71)

Nitrous Menus: Nitrous1 (N2O-1) and Nitrous2 (N2O-2) 70
Percent, Final Percent, and a Build Time. For advanced Nitrous and Fuel ramps use the Nitrous Graph Setup
and the Fuel Graph Setup menu selections.
NOTE—This selection is provided so that Quick and Easy Nitrous Power Ramps can be created. This selection
has limited user adjustment of the power ramp and fuel delivery. Also, Quick Setup will make the fuel graph the
same as the nitrous graph. Please see the Nitrous Graph Setup and Fuel Graph Setup menu selections for
advanced control.
Access from the Controller:
From the
Main screen , select the stage by pressing the “N2O-1” button or the "N2O-2" button. Press the
“DOWN” arrow button repeatedly until the "Nitrous Quick Setup" menu selection is highlighted and then press
the “ENTER” button. Using the “UP” and ”DOWN” arrow buttons, select the setting to be changed and hit
"ENTER". Adjust the setting and press the “SAVE” button to accept the new setting or press the “ESC” button to
exit with no change.
After all settings have been determined press the “BACK” button, press the “YES” button to accept the New
Nitrous Power Ramp settings or “NO” to exit without saving the new settings.
When a New Nitrous Power Ramp is saved, the Nitrous and Fuel Tables are updated with the Quick Setup
Data.
Access from the Computer Program:
From the
Status screen , select the stage by pressing either the "Nitrous1" button or the "Nitrous2" button. The
"Nitrous Quick Setup" options are found in the "Nitrous Quick Setup" dialog box under the "Nitrous Graph" Tab.
Click the "UP" and "DOWN" arrow buttons or type in any numeric value in the valid ranges shown in the different
settings below. Press the "APPLY" button to confirm the changes.
Start Percent
This setting determines the Nitrous Starting percentage. The Start Percent can be less than or greater than the