Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 61)

Global Menu / Setup-Options 60
Access from the Controller:
From the
Main screen , press the “GLOBAL” button. Press the “ENTER” button to select the Copy Current
Program menu. Using the “UP” and “DOWN” arrow buttons select the desired setup to copy the current
program to and press “ENTER”. Press "YES" to copy the current program or "NO" to abort the operation.
NOTE—When asked to make a selection from a “Message Box” the default selection will be chosen after 20
seconds.
Access from the Computer Program:
From the
Status screen , press the "SETUP" button. The copy current program option is found in the "Program"
dialog box under the "Options" Tab. Select the desired setup to copy the current program to from the pull-down
menu and click the "COPY" button. Click "YES" to copy the current program or "NO" to abort the operation.
5.3 Hold & Wait
This setting allows the progressive system to Hold & Wait when one of the activation criteria are removed.
Example - the throttle is lifted due to wheel spin. The Hold & Wait feature allows the progressive system to
resume at the point where the throttle was lifted.
Resume settings can be used to create a resume ramp. If the
Hold & Wait option is disabled and the throttle is lifted, the nitrous and fuel flows will start over at the beginning
of the progressive ramp, along with any applicable cycle start delays. The inputs that will activate the Hold &
Wait feature are:
Arming Input
Clutch Input
Clutch sensor (Analog1) - If enabled
TPS Input - If enabled
NOTE—If this option is "OFF" the progressive system and all timers will reset each time any of the arming
criteria are removed.
Access from the Controller:
From the
Main screen , press the “GLOBAL” button. Press the “DOWN” arrow button repeatedly until the "Hold