Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 124)

Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions 123
Default Sensor Setup Option
Use this to configure the controller to select the sensor calibration curve. There are two (2) standard sensors
available from LPE, both of which are pre-loaded into the NCC-002 firmware. If you don't plan to use one of the
LPE sensors, you can manually enter the calibration points. Whatever fuel pressure sensors are chosen for the
application, they MUST be 0-5 volt linear output sensors.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Fuel PSI
Menu is highlighted and then press the “ENTER” button. Press the "ENTER" button to select the "Default Sensor
Setup" option, then the “UP” or “DOWN” button to change the current selection. If the “BACK” button is pressed
no change will be made.
As shown in the screen shot below, the default fuel pressure sensors are:
•
L480250015: 0-15 PSI sensor
•
L480260150: 0-150 PSI sensor
Access from the Computer Program:
From the
Status screen , press the "SETUP" button. The "Default Fuel Sensor" setting is found under the "Fuel
Sensor" Tab. Click on one of the settings in the scroll-down menu and click "Accept" to select the default fuel
sensor setting.
Fuel Pressure Minimum Voltage
This setting should be set to the voltage the Fuel Sensor outputs at the minimum fuel pressure.
The Valid Range is 0.0 to 5.0 volts in .1 volt increments.
Access from the Controller:
From the
Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Fuel PSI
Menu selection is highlighted, and then press the “ENTER” button. Press the down arrow until the "Fuel PSI Min
Volt" selection is highlighted and then press the "ENTER" button. Use the “LEFT” and ”RIGHT” arrow buttons
adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit with no
change.