Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 User Manual
Page 168
Lingenfelter NCC-002 Nitrous Control Center Installation and Operating Instructions
167
9.5.2
Enabling the ECM’s tachometer signal output through EFILive Tune v7.5
1. In the "Navigation" window, under the "Calibrations" tab on the left side of the screen, double-click on
"System" and then "Tacho" to reach the tachometer related calibration parameters.
2. Double-click on ‘Parameters’ to bring up the window shown in following illustration, which should appear to
the right of the browser window. This calibration is currently set to communicate the tachometer signal via
CAN Bus, as shown by the blue dot on the depressed ‘CAN Bus’ button.
3. In the upper part of the same window, click on the ‘Crank’ button. Pressing this button enables the
tachometer signal output from the ECM. There should now be a blue dot on the depressed ‘Crank’ button,
showing that the selection has been changed.