Lingenfelter L460240000 Lingenfelter NCC-002 Nitrous Control Center v1.5 - Manual (Page 89)

Setup Menu 88
Out Menu" selection is highlighted and then press the “ENTER” button. Press the "DOWN" button until the
"Analog Out Graph Setup" is highlighted and then press the "ENTER" button. Use the “LEFT” and “RIGHT”
arrow buttons to move through the Analog Out settings. To Edit and/or change the Analog Out settings move the
cursor to the position to Edit and press the “EDIT” button. The editing cursor will appear at the position selected.
Using the “UP” and “DOWN” arrow buttons adjust the new setting. Press the “ENTER” button to accept the new
setting. Use the “LEFT” and “RIGHT” arrow buttons to move to the next set point. Each cursor position
represents One pulse of the Nitrous/Fuel Solenoid. Press the “EDIT” button and adjust the Analog Out voltage
as outlined above. Press “ENTER” to accept the new setting.
NOTE—When the two set points are more than one pulse apart the Analog Out voltage will be automatically
filled in between the set points.
There are several selections available when you press the “MENU” button. Below is the list of available options
along with their respective functions.
Exit: This selection exits the Graph Editor
Clear Data Points: This selection will clear any edit points that are set in the Graph Screen. This does
NOT change any Percentage setting (only the cursor is removed).
View Old Data: This selection will display the Progressive Ramp that is stored in memory.
Restore Old Data: This selection will restore the Progressive Ramp settings if any editing has been
done, but not saved.
Zoom In: This selection will zoom the X-axis in.
Zoom Out: This selection will zoom the X-axis out.
Press the “MENU” button to Exit and/or Save the new setting(s). From the Menu select Exit and press
“ENTER”. You will then be prompted to Save the new settings or Exit without saving.
Access from the Computer Program:
From the
Status screen , click on the "Analog Out" button. To move a single point, click on it and drag with
mouse up or down. You can use the "UP" and "Down" arrow keys to move the data point as well. By pressing
CTRL + UP/DOWN keys, you can move the data point in fine precision. To set an Edit point, double click on a
data point. An "X" will appear to mark the Edit point. When you select another point with a single click all points
between the Edit point and the Highlight point will auto fill as you drag the point. The SHIFT+LEFT/RIGHT keys
move the Highlight between data points. Use the scroll wheel and the right button on the mouse to zoom in or
out. Single click off from a data point and drag the mouse to move around a zoomed in window. Hit "ESC" or
double click off from data point to cancel selected edit point. You can also single click directly on highlighted Edit
point to cancel. Click CTRL-Z to undo.