Freescale Semiconductor MCF5480 - Manual (Page 254)

MCF548x Reference Manual, Rev. 3
8-4 Freescale Semiconductor
output for the processor’s sequential execution of single-cycle instructions (A, B, C, D...). Cycle counts
are shown relative to processor frequency. These outputs indicate the current processor pipeline status and
are not related to the current bus transfer.
The signal timing for the example in Table 8-2 is shown in Figure 8-3 .
Figure 8-3. PSTDDATA: Single-Cycle Instruction Timing
Table 8-3 shows the case where a PSTDDATA module captures a memory operand on a simple load
instruction: mov.l <mem>,Rx.
Table 8-2. PSTDDATA: Sequential Execution of Single-Cycle Instructions
Cycles PSTDDATA[7:0]
T+0, T+1 {PST for A, PST for B}
T+2, T+3 {PST for C, PST for D}
T+4, T+5 {PST for E, PST for F}
Table 8-3. PSTDDATA: Data Operand Captured
Cycle PSTDDATA[7:0]
T {PST for mov.l, PST marker for captured operand) = {0x1, 0xB}
T+1 {0x1, 0xB}
T+2 {Operand[3:0], Operand[7:4]}
T+3 {Operand[3:0], Operand[7:4]}
T+4 {Operand[11:8], Operand[15:12]}
T+5 {Operand[11:8], Operand[15:12]}
T+6 {Operand[19:16], Operand[23:20]}
T+7 {Operand[19:16], Operand[23:20]}
T+8 {Operand[27:24], Operand[31:28]}
T+9 {Operand[27:24], Operand[31:28]}
T+10 (PST for next instruction)
T+11 (PST for next instruction,...)
PSTDDATA
PSTCLK
{A, B} {C, D} {E, F}
Processor Clock
T+0 T+1 T+2 T+3 T+4 T+5 T+6