Chapter 26 programmable serial controller (psc), 1 introduction, 1 block diagram – Freescale Semiconductor MCF5480 User Manual

Page 763: 2 overview, 3 features, 4 modes of operation, Chapter 26, Programmable serial controller (psc), Introduction -1, Block diagram -1

Advertising
background image

MCF548x Reference Manual, Rev. 3

Freescale Semiconductor

26-1

Chapter 26
Programmable Serial Controller (PSC)

26.1

Introduction

This chapter describes the MCF548x programmable serial controller (PSC).

26.1.1

Block Diagram

A block diagram of the PSC/IrDA module is shown in

Figure 26-1

below.

Figure 26-1. PSC/IrDA Block Diagram

26.1.2

Overview

The PSC/IrDA module provides asynchronous, synchronous, and IrDA 1.1 compliant receiver/transmitter

serial communications. Each receiver and transmitter contains a 512-byte FIFO to reduce interrupt

overhead.
The MCF548x contains four programmable serial controllers.

26.1.3

Features

The primary features of the PSC/IrDA module are as follows:

Full duplex receiver and transmitter in all modes

Seven operation modes (UART, three soft modem modes, and three IrDA modes)

Two 512-byte FIFOs

26.1.4

Modes of Operation

The operation modes supported by the PSC/IrDA module are as follows.

Universal asynchronous receiver transmitter (UART) mode

Soft

MIR

FIR

SIR

UART

Modem

Serial

MUX

Bus

Control

Registers

FIFOs

Modem

CODEC

CODEC

CODEC

Interface

Co

mm Bus

Control

Mux

Ports

IP Bus

Advertising
This manual is related to the following products: