Freescale Semiconductor MCF5480 - Manual (Page 824)

MCF548x Reference Manual, Rev. 3
27-6 Freescale Semiconductor
25 PCSSE Peripheral chip select strobe enable. Selects between the DSPICS5 and PCSS functions. See
Section 27.7.3.5, “Peripheral Chip Select Strobe Enable (PCSS) ” for more information.
0 DSPICS5/PCSS is used as the DSPICS5 signal
1 DSPICS5/PCSS is used as PCSS peripheral strobe signal
24 ROOE Receive FIFO overflow overwrite enable. Enables an Rx FIFO overflow condition to either ignore
the incoming serial data or to overwrite existing data. If the Rx FIFO is full and new data is received,
the data from the transfer that generated the overflow is either ignored or shifted into the shift
register. If the ROOE bit is set, the incoming data is shifted into the shift register. If the ROOE bit is
cleared, the incoming data is ignored. See
Section 27.7.6.6, “Receive FIFO Overflow Interrupt
Request ” for more information.
0 Incoming data is ignored
1 Incoming data is shifted into the shift register
23–22,
20, 17
— Reserved, should be cleared.
21,19–18,1
6
CSISn Chip select inactive state. Determines the inactive state of the DSPICSn signal.
0 The inactive state of DSPICSn is low
1 The inactive state of DSPICSn is high
15–14 — Reserved, should be cleared.
13 DTXF Disable transmit FIFO. Provides a mechanism to disable the Tx FIFO. When the Tx FIFO is
disabled, the transmit part of the DSPI operates as a simplified double-buffered SPI. See
Section 27.7.2.3, “FIFO Disable Operation ” for details.
0 Tx FIFO is enabled
1 Tx FIFO is disabled
12 DRXF Disable receive FIFO. Provides a mechanism to disable the Rx FIFO. When the Rx FIFO is
disabled, the receive part of the DSPI operates as a simplified double-buffered SPI. See
Section 27.7.2.3, “FIFO Disable Operation ” for details.
0 Rx FIFO is enabled
1 Rx FIFO is disabled
11 CTXF Clear transmit FIFO. CTXF is used to flush the Tx FIFO. Writing a ‘1’ to CTXF clears the Tx FIFO
counter. The CTXF bit is always read as zero.
0 Do not clear the Tx FIFO
1 Clear the Tx FIFO counter
10 CRXF Clear receive FIFO. CRXF is used to flush the Rx FIFO. Writing a ‘1’ to CRXF clears the Rx FIFO
counter. The CRXF bit is always read as zero.
0 Do not clear the Rx FIFO
1 Clear the Rx FIFO counter
9–8 SMPL_PT Sample point. Allows the host software to select when the DSPI master samples DSPISIN in
modified transfer format. Figure 27-17 shows where the master can sample the DSPISIN pin.
00 0 system clocks between DSPISCK edge and DSPISIN sample
01 1 system clock between DSPISCK edge and DSPISIN sample
10 2 system clocks between DSPISCK edge and DSPISIN sample
11 Reserved
Table 27-3. DMCR Field Descriptions (Continued)
Bits Name Description