Hints – Tektronix Phaser 600 User Manual
Page 239
S
P E C I A L
P R I N T I N G
F E A T U R E S
2 2 3
Hints
■
When
Hot
is selected, the only available option for
Advance Media
is
Allow Hot Fusing
. Refer to
for more information.
■
Media fusing behaves differently with different media types (some media
may produce degraded print quality with fusing). Experiment until you get
the best results. Tektronix-supplied media usually look best with
cold-fusing.
■
When hot fusing is selected (or de-selected), the printer goes into a
warm-up (or cool-down) period for approximately 15 minutes. If hot fusing
has been selected, the printer’s warm-up time also increases when the
printer is turned on or comes out of standby mode.
■
If you do not have a supported printer driver, you can use the PostScript
utility files shipped on the printer’s CD-ROM or diskettes. Refer to