Tektronix Phaser 600 - Manual (Page 533)

S E T T I N G P O S T S C R I P T A N D H P - G L J O B A N D W A I T T I M E O U T S
5 1 7
Setting PostScript and HP-GL job
and wait timeouts
N O T E
The HP-GL job timeout is the same as the PostScript job timeout.
The following timeouts can be set in the printer:
■ The wait timeout is the amount of time in seconds that the printer waits for
data to come from the computer during a job. If the data stream pauses
for longer than the specified number of seconds, a timeout error is
generated and the job is canceled.
■ The job timeout is the amount of time any single job may be active before
it must print.
■
In PostScript mode, if the value is exceeded, a timeout error is
generated.
■
In HP-GL mode, if the timeout value is too small, an image may be split
across two pages; if the value is too large, multiple-page prints may be
combined on one page.