Tektronix Phaser 600 - Manual (Page 536)

S E T T I N G P O S T S C R I P T A N D H P - G L J O B A N D W A I T T I M E O U T S
5 2 0
4 To change CONFIG.PS to specify different timeouts, substitute new values for
the following lines.
N O T E
For timeout problems in Windows, also increase the Windows WaitTimeOut to 999.
See
Fixing timeout problems in Windows for instructions.
Time out Permitted
timeout values Suggested
timeout values
JobTimeOut 0, or 15 to 999 0
WaitTimeOut 0 to unlimited 0
(To avoid timeouts or job cancellation
on Windows multiple-page or
multiple-copy print jobs, you may want
to set the WaitTimeOut to a high value
or to zero.)
ManualFeedTimeout 0 to unlimited 300
(Five minutes should give you enough
time to reach the printer and load
media.)
To specify no timeout 0