Tektronix Phaser 600 - Manual (Page 689)

C L E A R I N G A M E D I A J A M
6 7 2
Hints
■ If media is not loaded and the front panel reports a media jam, open the
top cover and close it again to clear the error message.
■ Whenever jammed media extends from the exit path, remove it from that
location with a downward movement. Pulling media in the same direction
as the paper path leaves less residue inside the printer than backing
media out of the printer from the drum area.
■ After removing the jammed media, inspect the inside of the printer for
loose pieces of media and remove them.
■ If the printer frequently reports Clear Entrance Jam , make sure that
your media cuts are smooth and that you insert the media evenly; see
Cutting roll media .