Tektronix Phaser 600 User Manual
Page 534
S
E T T I N G
P
O S T
S
C R I P T
A N D
H P - G L
J O B
A N D
W A I T
T I M E O U T S
5 1 8
You can use the
CONFIG.PS
file to change the PostScript and HP-GL job and wait
timeout values. When sent to the printer, your edited version of the
CONFIG.PS
file
changes the values in the printer, but
only
while the printer is turned on; if the printer
is turned off or reset the values return to their defaults. To restore your desired
timeout settings, you must send your edited
CONFIG.PS
file to the printer again.
N O T E
The CONFIG.PS file affects printer operation. If the printer is shared on a network,
using this file may affect the prints requested by other users.
1
Configure the printer’s port to receive PostScript; see
for instructions.
2
Locate the utility files on the Phaser 600 printer’s CD-ROM; refer to
3
Copy the
CONFIG.PS
file to your hard disk, and open the file in a text editor.