Tektronix Phaser 600 - Manual (Page 518)

E N A B L I N G A N D D I S A B L I N G S Y S S T A R T J O B E X E C U T I O N
5 0 2
5 Select one of the following files from the list, then click Open . (These files
were installed in the Printer Utilities folder inside the PhaserTools folder.)
■
Use the Set SysStart Job file to enable automatic execution of the
SysStart job.
■
Use the No SysStart Job file to disable automatic execution of the
SysStart job.
6 At the prompt Save PostScript output as: you are asked for a file name
for saving printer output. Use either the default name given in the edit box or
type a new name.
7 Click Save to send the file to the printer.
8 If no output is returned by the printer, the LaserWriter Utility displays a dialog
box; click OK to continue.
If output is returned by the printer, you won't see this dialog box; check your
hard disk for the file the utility created for the printer's output.