Tektronix Phaser 600 - Manual (Page 57)

I N S T A L L I N G T H E S T A R T E R P A P E R R O L L
4 1
3 Loosen the plastic nut by turning it
until the endcap slides freely.
4 Slide the removable endcap from the
shaft.
5 Slide the paper roll onto the shaft
(make sure that the leading edge of
the paper comes off the roll from
behind, as shown); center the roll
over the fixed endcap.
C A U T I O N
Gently slide the paper roll onto the shaft;
do not let it drop onto the shaft or it can
damage the fixed endcap.
4 5
9480-36
9480-35