Tektronix Phaser 600 - Manual (Page 677)

M E D I A H I N T S A N D T I P S
6 6 0
Cutting roll media
If the roll media misfeeds because of a jagged or crooked leading edge, follow
these rules:
■ Replace the cutter if the media’s leading edge is jagged (see Removing the
fuser components for instructions).
■ Make sure that the knife you use for manual cutting has a new, sharp
blade.
■ If you are using very thick media, such as canvas or fabric, cut it manually
with the cutting tool provided with the printer, rather than use the automatic
cutter.