Tektronix Phaser 600 - Manual (Page 59)

I N S T A L L I N G T H E S T A R T E R P A P E R R O L L
4 3
Feeding roll paper
1 When the printer is in the Ready state, the front panel displays this message:
2 Make sure that the paper’s leading edge is straight and smooth.
If it is not, use the cutting tool that was shipped with the printer to cut a
smooth edge along the printer’s cutting guide. Refer to
Cutting roll media
for complete instructions on getting a straight leading edge.
9480-12.CD
Ready
Pause Menu
9480-69