Inserting the fuser components – Tektronix Phaser 600 User Manual
Page 578
Advertising
O
C C A S I O N A L
C L E A N I N G
5 6 2
Inserting the fuser components
Whether you are inserting new
components or re-inserting the existing
ones, follow these steps:
1
Insert the cutter blade into its slot
on the fuser shuttle, making sure
that the exposed blade is facing
up, as shown.
2
Make sure that the cutter is seated in the slots on the
fuser; secure the cutter by sliding the locking lever.
9480-46.CD
9480-61.CD
Advertising