Tektronix Phaser 600 - Manual (Page 690)

C L E A R I N G A M E D I A J A M
6 7 3
Clearing a media jam
1 Cut the media if you are using roll media. If
not, go to Step 2.
With the paper roll cover open, use a sharp knife
(such as the cutting tool included with the printer)
to trim the jammed media. Use the printer’s
cutting guide to make a clean cut.
2 Move the printhead.
a Open the top cover.
b Using an object such as a pen, move the
hot printhead to the far right. If you do not
do this, you might damage the printhead
when you remove the media.
W A R N I N G
The printhead is hot. To avoid injury, do not use your hand to move the printhead.
9480-69
9480-114
a
b