Xylem IM167 R8 Aquavar CPC (Centrifugal Pump Control) - Manual (Page 13)

13
INTRODUCTION
Study these installation instructions carefully before proceeding. Failure to observe the
warnings and instructions may cause a malfunction or personal hazard.
WARNING! Before you begin read “Safety” on page 7.
Installation Flow Chart
The installation of the AQUAVAR adjustable speed pump controller follows the outline below.
The steps must be carried out in the order shown. At the right of each step are references to
the detailed information needed for the correct installation of the unit.
Task See
PREPARE for installation “Preparing for Installation” on page 15.
UNPACK the drive “Unpack the Drive” on page 21.
PREPARE the Mounting Location “Prepare the Mounting Location”
on page 21.
REMOVE the front cover “Remove Front Cover” on page 21.
MOUNT the drive “Mount the Unit” on page 22.
INSTALL wiring “Install the Wiring” on page 23.
CHECK installation “Check Installation” on page 32.
REINSTALL the cover “Reinstall Cover” on page 33.
APPLY power “Apply Power” on page 33.
START-UP “Start-Up” on page 33.