Xylem IM167 R8 Aquavar CPC (Centrifugal Pump Control) - Manual (Page 70)

70
Defaults
Group
Energy Range Description Single Synch- Multi- Constant Speed
26 Savings Pump ronous Control Slave Control
2605 Energy Save Resets energy savings counter. Dis- Dis- Dis- Dis- Dis-
Reset After resetting, parameter 2605 abled abled abled abled abled
returns to disabled.
Disabled
Reset
Group Option
Range Description
Single Synch- Multi- Constant Speed
30 Modules Pump ronous Control Slave Control
3001 Comm Protocol Activates the optional external No No No No No
Select DCS and selects the interface.
Refer to the ABB IOM chapter
on fieldbus control. Can be used
only with Single Pump, Constant
Slave or Speed Control modes.
Not Selected No fieldbus communication. Aquavar Aquavar
(Default)
Std Modbus Drive uses Modbus protocol on
the standard RS485 port.
Protocol settings are in group 32.
Ext Fba The drive communicates with a
fieldbus adapter module in
option slot 2 of the drive. Note
when Ext Fba is selected Param-
eter Groups 31 is unlocked.
Aquavar This protocol is used for
communication between the
drives in the Synchronous and
Multicontrol macros.
Group Fieldbus
Range Description
Single Synch- Multi- Constant Speed
31 Setup Pump ronous Control Slave Control
3101 FBA Type This parameter configures the
module type automatically by
the fieldbus adapter. No action
is required by the user unless
changes to default settings are
desired. Refer to the fieldbus
manual.
3102- FBA Parameters Meaning and values of these
3133 parameters depend on the
fieldbus option connected to
the drive.
PARAMETER LISTINGS