Parameter listings – Xylem IM167 R8 Aquavar CPC (Centrifugal Pump Control) User Manual

Page 51

Advertising
background image

51

Aquavar CPC Parameter List

(continued)

Group 19, ANALOG OUTPUTS – Defines the analog outputs available on the drive. Two
possible analog outputs that can be used to monitor various parameters (AO1, AO2).

Group 21, REGULATE – Defines type of control regulation with analog input from transducer.
Normal, Inverse modes. Friction loss compensation.

Group 22, MULTIPUMP CONTROL – Defines parameters for multi-pump control algorithm.
Addresses each drive. Required group for alternating each pump.

Group 24, FAULT FUNCTIONS – Defines parameters for faults, pump protection and run
enable mode (e.g. keypad failure, pump protect, low water, error reset).

Group 25, AUTOMATIC RESET – This group defines conditions for automatic reset. An
automatic reset occurs after a particular fault is detected. The Aquavar holds for a delay time,
then automatically restarts. You can limit the number of restarts in a specific period of time for
a variety of faults (e.g. overcurrent, over/ under voltage).

Group 26, ENERGY SAVINGS – Defines parameters used for energy savings, and kW/hr
usage.

Group 27, CRITICAL SPEEDS – This group defines up to three critical speeds or resonant
frequencies. This mechanical resonance may occur on certain loads at certain frequencies.

Group 30, OPTION MODULES – Defines parameters used for fieldbus communication
networks and optional fieldbus adapter.

Group 31, FIELD BUS SETUP – Parameters used for actual set up for the field bus
communication via the RS485 terminals.

Group 32, MODBUS SETUP – Defines parameters used for the Modbus setup and protocol,
baud rate, parity, status functions.

Group 50, MOTOR CONTROL – Provides adjustment of the switching frequency for the drive.

Group 51, MAINTENANCE TRIGGERS – Defines the parameters for trigger points on the
cooling fan, motor revolutions, run time, used power in Megawatts. Provides actual time run
on each component.

Group 99, INFORMATION – Provides firmware version, drive rating for the Aquavar.

PARAMETER LISTINGS

Advertising